HICEM Flex-Shield : Stylene Acrylic Emulsion

HICEM Flex-Shield : Stylene Acrylic Emulsion

Flexible-waterproof cementitious coating for roof floor and wall

 

Product code : S12, S13

Price : XXX (Contact distributors) baht / 1.0 litre/gallon 

Quantity : 1 litre/gallon (12 gallons/carton)

5 litres/gallon (6 gallons/carton)

25 litres/gallon 

Using quantity : 4–5 square meter/litre approximately

Storage : Keep container tightly closed.

HICEM Waterproof-Shield is one component additive emulsion modified cementitious waterproof slurry mortar. It is high performance of flexibility coating to flat concrete & mortar such as roofs and walls. On curing it forms an excellent waterproof and protective elastomeric layer over the surface & thus prevent water infiltration.

  • Waterproofing – waterproof for concrete structures.
  • Water permeability – Remarkable resistance towards ingression of water.
  • Adhesion – Excellent adhesion to concrete, natural & artificial stone.
  •  Flexibility – Provides excellent flexible coating.
  • Temperature Resistance – high temperature resistance.
  • Usability: Pre-batched components-slurry/trowelable consistency – mix & apply easily.
  •  Carbonation – Prevent concrete carbonation (Anti-efflorescence)
  • Slip Resistance – Imparts slip resistance to the applied surface.
  • Corrosion Protection – Non corrosive to steel & iron.

Surface preparation

  • The surface to be applied should be clean & sound, free from any kind of contamination, dirt etc. Thoroughly wire brush the surface & clean the dust by air compressor or by water jetting. Oil & grease must be removed using degreasing solvents.
  • Any damaged surface must be repaired by using crack fillers or polymer modified repair mortar.
  • The substrate must be properly pre-wetted to a saturated-dry condition.
  • Transfer homogeneous milky color of HICEM Waterproof-Shield Emulsion into a suitable clean mixing container. 
  • Gradually start addition Cement powder into HICEM Waterproof-Shield emulsion. Using HICEM Waterproof-Shield: Portland Cement at the mixing ratio of 1 by 1.
  • Stirring until it becomes a uniform free flowing slurry.
  • Apply slurry coat over the surface needed by a masonry brush or roller. In case two coats are specified, the second coat shall start after the first coat at least 20 min or it is completely dried. For overcoating, allow the second coat to harden for at least 3 days prior to overcoating.
  • Keep the rest of HICEM Waterproof-Shield tight in gallon or container to avoid air exposure.   

 

  • Do not add extra water for dilution.
  • Always add Cement powder (Portland or Mixed Cement with no sand) into HICEM Waterproof-Shield 
  • Do not expose the applied substrate to water until it is completely cured.

HICEM Waterproof-Shield is suitable for 

  • Interior and exterior waterproofing & damp-proofing of old or new concrete, cementitious rendering, brickwork and blockwork.
  • Exterior waterproofing of basement retaining walls in new construction & refurbishment.
  • Sealing internal basement walls against dampness.
  • Water tanks & Swimming pools.
  • Concrete floor & roof slabs, floors, balcony, bathroom floors.
  • Bridge decks, canals, sewage treatment areas etc.
  • Waterproof bottom coating for tiles, granite, marble & other natural stones.

Appearance and Color milky white

Viscosity 700 – 1500 cPs

pH Value 7.5 – 8.5

Density 1.03 g/m3

Film Appearance Clear, transparent, Flexible